CADSoftTools

I am exporting some drawings to emf file and then after loading that emf file, export it to DXF.

The original polylines in the source drawing are shown as multiple simple lines in the ultimate DXF.

Is there some solution to overcome this problem. Please help me.

thanking you in anticipation

Hello,

When exporting through Metafile the complicated entities are split to a set of simple ones: lines, arcs etc. This is restriction of Metafile usage. The problem can be solved by the direct export. We work on this problem and when direct export will be ready we will inform you.

Sergey.

please post questions to the forum or write to support@cadsofttools.com