CADSoftTools

Hi:

I have a problem when inserting blocks with attributes, everything is as it should be, but at the end of the block insertion and refresh the contents of the drawing, the attributes of each block are drawn with the wrong coordinates (visually) but if I save the drawing and then open the saved file, everything is as it should be is, the attributes of the blocks are drawn in the correct position.

Any idea what may be lacking to refresh or load, after insertion of the blocks with attributes?

Thanks!!

Hello Felipe,

If you are using TsgDrawingNavigator component, calling the TsgDrawingNavigator.Refresh method should be enough for redrawing the image. We will look into the described issue.


Mikhail