CADViewX 7.2 on Windows 2000?

sta · Post by **sta** » 22 Oct 2010, 17:03

Is this still supported? It is listed on the requirements page...

We have trouble with downloaded version: CADViewLib.ocx is not registered at the end of the installation, with the message stating that regsvr32 gives status code 0x3. Running it manually gives the same result, with the message saying LoadLibrary("CADViewLib.ocx") failed - The specified module cannot be found.

The machine has Windows 2000 with Service Pack 4.

Regards
sta

Post by **support** » 25 Oct 2010, 10:43

Hello.
Thank you for the remark. Unfortunately there is some error on registration under Windows 2000. We will consider this problem and inform you when a solution is ready.

Alexander.

CADSoftTools