Generating G-code omitting contours

[REGINALD B. CASS]

I have read a previous post and am still unable to generate a proper G-code from a dxf file.

I do not know how to attache my dxf file but can email a copy of the file you will provide an email address I can send it to:

The following information are my parameters:
I am having a problem with creating G-code on my project, because it appears that the intersection of contours and lines are not being established.

I have attached 2 files, one a DWG and the other DXF of the project that I am working on and can not get the G-Code generator to recognize the intersection of a contour and a line.

I have reviewed the drawings many times and do not suspect any drafting errors.

The software generator that I am using is AB Viewer, Version 15.

The software that I am using to review the generation of G-code is: NC Viewer GCode Viewer and Machine simulator.

The software that I am using to run the G-code is: gSender

The following snip displays that the contours and lines do not connect.

Any solution to this problem?

Thank you.

Reg

[support]

I have read a previous post and am still unable to generate a proper G-code from a dxf file.

I do not know how to attache my dxf file but can email a copy of the file you will provide an email address I can send it to:

The following information are my parameters:
I am having a problem with creating G-code on my project, because it appears that the intersection of contours and lines are not being established.

I have attached 2 files, one a DWG and the other DXF of the project that I am working on and can not get the G-Code generator to recognize the intersection of a contour and a line.

I have reviewed the drawings many times and do not suspect any drafting errors.

The software generator that I am using is AB Viewer, Version 15.

The software that I am using to review the generation of G-code is: NC Viewer GCode Viewer and Machine simulator.

The software that I am using to run the G-code is: gSender

The following snip displays that the contours and lines do not connect.

Any solution to this problem?

Thank you.

Reg

Hi Reg,
Please, send me your files and screesnhots at support@cadsofttools.com, as I need this information to help you out.

Best regards,