Generating G-code omitting contours
Posted: 11 Nov 2023, 01:47
I have read a previous post and am still unable to generate a proper G-code from a dxf file.
I do not know how to attache my dxf file but can email a copy of the file you will provide an email address I can send it to:
The following information are my parameters:
I am having a problem with creating G-code on my project, because it appears that the intersection of contours and lines are not being established.
I have attached 2 files, one a DWG and the other DXF of the project that I am working on and can not get the G-Code generator to recognize the intersection of a contour and a line.
I have reviewed the drawings many times and do not suspect any drafting errors.
The software generator that I am using is AB Viewer, Version 15.
The software that I am using to review the generation of G-code is: NC Viewer GCode Viewer and Machine simulator.
The software that I am using to run the G-code is: gSender
The following snip displays that the contours and lines do not connect.
Any solution to this problem?
Thank you.
Reg
I do not know how to attache my dxf file but can email a copy of the file you will provide an email address I can send it to:
The following information are my parameters:
I am having a problem with creating G-code on my project, because it appears that the intersection of contours and lines are not being established.
I have attached 2 files, one a DWG and the other DXF of the project that I am working on and can not get the G-Code generator to recognize the intersection of a contour and a line.
I have reviewed the drawings many times and do not suspect any drafting errors.
The software generator that I am using is AB Viewer, Version 15.
The software that I am using to review the generation of G-code is: NC Viewer GCode Viewer and Machine simulator.
The software that I am using to run the G-code is: gSender
The following snip displays that the contours and lines do not connect.
Any solution to this problem?
Thank you.
Reg