"Out of memory"
Moderators: SDS, support, admin
"Out of memory"
I have
- Cadview 14
- Total Commander 32 bit
- 32 GB RAM
- a DXF with 260 MB
To view it with Ctrl+Q, it runs the progress bar from 0 - 100 %, and then it shows a dialogue: "Out of memory"
The PC uses obly 8 of 32 GB RAM.
Why there is not enough memory?
- Cadview 14
- Total Commander 32 bit
- 32 GB RAM
- a DXF with 260 MB
To view it with Ctrl+Q, it runs the progress bar from 0 - 100 %, and then it shows a dialogue: "Out of memory"
The PC uses obly 8 of 32 GB RAM.
Why there is not enough memory?
Re: "Out of memory"
Hello Peter,
It appears that you have reached the 32-bit architecture memory limit (approximately 3.3 GB per process). Please check how much memory is used by TOTALCMD.EXE process, in case it's ~ 3.3 GB when loading the 260 MB DXF, you should use Total Commander 64 bit (TOTALCMD64.EXE).
Mikhail
It appears that you have reached the 32-bit architecture memory limit (approximately 3.3 GB per process). Please check how much memory is used by TOTALCMD.EXE process, in case it's ~ 3.3 GB when loading the 260 MB DXF, you should use Total Commander 64 bit (TOTALCMD64.EXE).
Mikhail
Technical Support E-mail: support@cadsofttools.com
Chat support on Skype: cadsofttools.support
Chat support on Skype: cadsofttools.support
Re: "Out of memory"
Hi
it uses "only" 1.7 GB. See picture - taken 1 sec. before error-message.
it uses "only" 1.7 GB. See picture - taken 1 sec. before error-message.
- Attachments
-
- tc_quickview.png (135.1 KiB) Viewed 8662 times
Re: "Out of memory"
Solved - with TC64 it goes up to 2.2 GB and shows it well.