G Code
Moderators: SDS, support, admin
G Code
Good morning
We have a question. Is it possible to contemplate decimals in conversion to g-code ?
We see that if it is a value with decimals it rounds it and when we process the code g the result produced does not fit in dimensions with the original.
Thanks
We have a question. Is it possible to contemplate decimals in conversion to g-code ?
We see that if it is a value with decimals it rounds it and when we process the code g the result produced does not fit in dimensions with the original.
Thanks
Re: G Code
Hello,
There is a CADtoGCode.Precision property which sets the number of digits after the decimal point.
Mikhail
There is a CADtoGCode.Precision property which sets the number of digits after the decimal point.
Mikhail
Technical Support E-mail: support@cadsofttools.com
Chat support on Skype: cadsofttools.support
Chat support on Skype: cadsofttools.support